ScootDawg Forums

ScootDawg Forums (http://www.scootdawg.net/index.php)
-   3-Wheeled Scooters (http://www.scootdawg.net/forumdisplay.php?f=57)
-   -   K & n (http://www.scootdawg.net/showthread.php?t=54958)

Irish 05-06-2015 11:29 AM

K & n
 
Just out of curiosity , I was wondering if anyone had luck with K & N Products? When I lived in NH , I used their air filters on a lot of Triumph engs that I built up (improved performance on ) I had very good luck with them! Everything is different here in Fla. Even different lubrications are used so I was wondering if anyone used these products.:thanks: Irish

cheapeto 05-07-2015 07:12 AM

I have a K&N in my Honda.

Irish 05-07-2015 11:09 AM

K & n
 
Cheapto (sp?)---Did you notice any difference in performance? I put one in my 2006 Sportster 1200 w/ Trike Kit & I can't tell if there is any difference. It has so much power anyway that it's hard to tell without a run on the strip or a dyno test.:shrug: Thanks! Irish

cheapeto 05-08-2015 07:16 AM

Oh yeah, I had to adjust the A/F setting. It was about that time I installed a TinyTach, to reset my idle setting properly.
There is a procedure to adjust my valves, when the engine is hot and running.
But I found it damn near impossible to set it with out a tach. I could get it close, so I ran without the side covers on for a week or 2, making adjustments after the TT.
I'm still not crazy happy with my settings yet, but the CON ride is coming up, so when I get down to North Carolina, I'll get one of the real mechanics to set it up for me proper like.
Being a 250cc I try and squeek every bit of power from it that I can. Re-jetting/drilling out the port on the vacume slide, slider/roller combination, a blue Polini heavier contra spring in the variator.
A Delta clutch is next years upgrade.
Take care


All times are GMT -4. The time now is 09:16 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.