Forum: General Scooter Discussion
07-20-2021, 09:42 AM
|
Replies: 3
Views: 4,319
When I had my TaoTao, Lancer, the fast idle,...
When I had my TaoTao, Lancer, the fast idle, enricher, never really worked right.
It would start fast but the drop off within seconds, and stall. I had to baby the throttle until it warmed up a bit...
|
Forum: 125cc - 249cc
08-07-2019, 09:46 AM
|
Replies: 5
Views: 4,011
Another thought, not yet mentioned ... perhaps...
Another thought, not yet mentioned ... perhaps check the bolts that secure the engine halves. If one was not torqued properly, it could allow a leak. Don't over-tighten, but verifying they are might...
|
Forum: 250cc +
11-21-2018, 08:09 AM
|
Replies: 5
Views: 15,663
|
Forum: 50cc - 124cc
10-23-2018, 01:13 PM
|
Replies: 5
Views: 26,584
|
Forum: 125cc - 249cc
10-12-2018, 01:40 PM
|
Replies: 7
Views: 3,985
|
Forum: 125cc - 249cc
10-11-2018, 12:14 PM
|
Replies: 7
Views: 3,985
|
Forum: General Scooter Discussion
08-31-2018, 05:33 PM
|
Replies: 3
Views: 4,451
|
Forum: General Scooter Discussion
07-10-2018, 02:25 AM
|
Replies: 13
Views: 18,277
Welcome to the forum, Terry.
I don't know...
Welcome to the forum, Terry.
I don't know anything about the Zuma, but...
Is the 2 Brothers pipe a performance exhaust.? Perhaps the EFI can't keep up with it at speed ... on a carbureted bike, you...
|
Forum: General Scooter Discussion
06-21-2017, 05:51 PM
|
Replies: 12
Views: 6,304
|
Forum: General Scooter Discussion
06-05-2017, 02:39 PM
|
Replies: 4
Views: 3,265
New to me Scoot
I decided that I had enough fun with my TaoTao, Lancer 150, and upgraded to a Suzuki, Burgman 400.
I've had the Lancer for 2 years now and gained a lot of knowledge and experience from it. It was my...
|
Forum: 125cc - 249cc
03-30-2017, 06:58 AM
|
Replies: 11
Views: 8,340
Pete,
When I first read this, I envisioned this...
Pete,
When I first read this, I envisioned this split along the pipe, rather than at the seam; Reading again, I see that's what you had said.
How does this muffler and pipe fit? What I'm asking is,...
|
Forum: 125cc - 249cc
03-29-2017, 08:22 AM
|
Replies: 11
Views: 8,340
Is the engine running lean, possibly?
How does...
Is the engine running lean, possibly?
How does the plug look?
I have a 150cc TaoTao, and have never had any issues with the header pipe ... the muffler clogged, probably from over-rich, but that's...
|
Forum: 125cc - 249cc
03-09-2017, 07:23 PM
|
Replies: 2
Views: 5,866
Congratulations on the new scoot.
I have a...
Congratulations on the new scoot.
I have a Lancer too, and am quite pleased with it. I had watched the Youtube, video series (episode #1 linked below) prior to purchasing mine. Even though it...
|
Forum: 125cc - 249cc
08-13-2016, 10:38 PM
|
Replies: 3
Views: 5,726
|
Forum: 125cc - 249cc
08-11-2016, 04:17 PM
|
Replies: 7
Views: 5,329
I had a similar situation to this and I've...
I had a similar situation to this and I've attached the link to that thread.
In my case, I had replaced the R/R and checked the stator. After changing up the pin configuration at the R/R, it has...
|
Forum: 125cc - 249cc
07-27-2016, 10:17 PM
|
Replies: 9
Views: 11,443
For what it's worth ... I had replaced my belt...
For what it's worth ... I had replaced my belt with the longer, 842, but as of today, switched back.
It seemed to affect the RPMs and acceleration in a negative way. It was slow up to speed; once...
|
Forum: 125cc - 249cc
07-27-2016, 09:54 PM
|
Replies: 1
Views: 4,266
|
Forum: 125cc - 249cc
07-13-2016, 12:43 PM
|
Replies: 9
Views: 11,443
|
Forum: The Dawg Pound
07-12-2016, 02:49 AM
|
Replies: 22
Views: 23,901
Here's one for you, Irish.
My uncle had bought...
Here's one for you, Irish.
My uncle had bought a '71 Triumph 250, T25T, internet photo shown below. Before he moved out west, he gave it to me (needed a clutch). I used it ride it back and forth to...
|
Forum: General Scooter Discussion
07-12-2016, 02:09 AM
|
Replies: 6
Views: 5,735
Thanks rks. I haven't looked for the Nylon...
Thanks rks. I haven't looked for the Nylon washers yet, but I like the idea for simplicity.
This weekend I did an oil change and gear oil as well. I used the brush-on, Teflon, thread sealant. It has...
|
Forum: 125cc - 249cc
06-30-2016, 09:00 PM
|
Replies: 6
Views: 4,996
|
Forum: 125cc - 249cc
06-30-2016, 01:41 PM
|
Replies: 6
Views: 4,996
Mawby,
I have a Lancer too.
After I had done...
Mawby,
I have a Lancer too.
After I had done some minor carb tweaks, I had an issue with mine idling. I had to step up the A/F mixture quite a bit. I have re-jetted mine and added a cone, air...
|
Forum: General Scooter Discussion
06-23-2016, 01:51 PM
|
Replies: 7
Views: 11,175
Welcome to the forum, Woody.
I don't have the...
Welcome to the forum, Woody.
I don't have the 50, but the engines are basically the same ... and yes, GY6.
I've had my TaoTao, 150 for a year now and have about 1,700 miles on it. With good...
|
Forum: General Scooter Discussion
06-03-2016, 07:19 PM
|
Replies: 6
Views: 5,735
Thanks for the replies.
Does no one make a...
Thanks for the replies.
Does no one make a superior washer, other than aluminum. I was thinking of something like the ones I have for my daughter's RAV4, that appear to be a fibrous paper on an...
|
Forum: General Scooter Discussion
05-31-2016, 08:01 PM
|
Replies: 6
Views: 5,735
Gear Oil Drain Plug
Hey,
I have had a small leak from my gear oil drain plug. I'm not sure if I used a new washer in previous oil changes or not ... I can't seem to find replacements anywhere.
I was wondering if...
|