Go Back   ScootDawg Forums > Search Forums
Showing results 1 to 23 of 23
Search took 0.01 seconds.
Search: Posts Made By: Dodgeme
Forum: ScootDawg Rally Info 08-13-2015, 10:25 PM
Replies: 59
Views: 63,380
Posted By Dodgeme
as a further thought we will all need to be...

as a further thought we will all need to be informed of the regulations wherever we go because some states require motorcycle licenses, some require anything above 50cc to be registered some require...
Forum: 50cc - 124cc 08-13-2015, 03:00 AM
Replies: 7
Views: 9,332
Posted By Dodgeme
unfortunately I have to disagree because mine did...

unfortunately I have to disagree because mine did 50mph clocked by gps, chase cars, and a police radar gun going up a 4% grade and that was only at a 47mm bore with only a 1500 rpm gearbox side cvt...
Forum: 50cc - 124cc 08-11-2015, 11:50 PM
Replies: 7
Views: 9,332
Posted By Dodgeme
Yes knowing the rpms is a good point but you can...

Yes knowing the rpms is a good point but you can do a lot with these little engines once you know. The next changes I would make are for airflow efficiency a stock cam is at its limit at 80cc. I...
Forum: 50cc - 124cc 08-11-2015, 11:34 PM
Replies: 7
Views: 9,332
Posted By Dodgeme
First a 150cc engine will not bolt into a 50cc...

First a 150cc engine will not bolt into a 50cc chassis. next its actually pretty simple to get more out of those engines.
Forum: 50cc - 124cc 08-11-2015, 11:26 PM
Replies: 1
Views: 1,610
Posted By Dodgeme
I am assuming you are using a d.v.o.m. (Digital...

I am assuming you are using a d.v.o.m. (Digital Volt Ohm Meter) to check voltages. To start check for other ground locations and clean them all with some sort of abrasive if the problem persists...
Forum: 125cc - 249cc 08-11-2015, 11:02 PM
Replies: 6
Views: 1,835
Posted By Dodgeme
the 2 copper terminals in that prior picture go...

the 2 copper terminals in that prior picture go to battery pos. and to starter the silver terminals usually go 1 to ground 1 to switched source the silver terminals however to be used in this...
Forum: 50cc - 124cc 07-30-2015, 12:31 AM
Replies: 8
Views: 6,707
Posted By Dodgeme
I currently run a slightly modified with10 in...

I currently run a slightly modified with10 in rim, a moderately modified the one I referred too initially with a 130-70-12 tire, and my all out race spec engine 12 in rim (the one I referred to...
Forum: 50cc - 124cc 07-30-2015, 12:28 AM
Replies: 8
Views: 6,707
Posted By Dodgeme
you would be surprised what you can do with ...

you would be surprised what you can do with several cnc milling ad lathe machines and about 200 hrs just on flowbenches
Forum: General Scooter Discussion 07-27-2015, 04:34 PM
Replies: 68
Poll: Oil?
Views: 71,212
Posted By Dodgeme
run the 5w40 in the colder months (if you are...

run the 5w40 in the colder months (if you are expecting sub 32 degree F temps) that 10w40 is actually for temps above 32 degrees F if you get into the temp oil charts. I run the 10w40 in those sub...
Forum: General Scooter Discussion 07-27-2015, 04:05 PM
Replies: 68
Poll: Oil?
Views: 71,212
Posted By Dodgeme
I use the scooter mfg. recommended 15w40 however...

I use the scooter mfg. recommended 15w40 however I use the gasoline/diesel engine compatible royal purple. And I absolutely love the way it runs with it. 5k miles per year. and my engine, cvt, and...
Forum: The Dawg Pound 07-24-2015, 01:24 AM
Replies: 214
Views: 114,156
Posted By Dodgeme
Those whom cannot remember the past are condemned...

Those whom cannot remember the past are condemned to repeat it. Quoted from unknown holocaust victim circa WWII.
Forum: The Dawg Pound 07-24-2015, 01:18 AM
Replies: 7
Views: 4,254
Posted By Dodgeme
needs a v8 jk that would be insane and somebody...

needs a v8 jk that would be insane and somebody probably already did it
Forum: The Dawg Pound 07-24-2015, 01:14 AM
Replies: 23
Views: 9,472
Posted By Dodgeme
I still believe that a manual shift...

I still believe that a manual shift nonsynchronized or better yet a crashbox car or pickup truck with power nothin (no power windows no power steering, no power brakes, no radio, NO CUPHOLDERS, no...
Forum: 50cc - 124cc 07-24-2015, 12:33 AM
Replies: 8
Views: 6,707
Posted By Dodgeme
I know mine is an extreme case last time I threw...

I know mine is an extreme case last time I threw it on a dyno it cranked 20 hp at 4k rpm and 45 ft lbs of torque at 3500 and that's when it was discovered that the exhaust was limiting me to 4k rpm...
Forum: 50cc - 124cc 07-24-2015, 12:18 AM
Replies: 8
Views: 6,707
Posted By Dodgeme
don't diss the 50cc's ability to contend you...

don't diss the 50cc's ability to contend you should see mine it will keep up with most, in both acceleration and top speed (mine currently does 65 mph at 4k rpm) What has been done to mine is a 52mm...
Forum: General Scooter Discussion 07-23-2015, 11:43 PM
Replies: 36
Views: 17,718
Posted By Dodgeme
mine is used for half of my commute to and from...

mine is used for half of my commute to and from my civilian employer as well as for errands, unfortunately my civilian employer supplied work vehicle runs on diesel and gets about 7 mpg,however I put...
Forum: 50cc - 124cc 07-22-2015, 12:28 AM
Replies: 11
Views: 9,649
Posted By Dodgeme
sea foam works by (for lack of a better phrase)...

sea foam works by (for lack of a better phrase) steam cleaning the combustion chamber not with water but with a petroleum distillate based cleaning chemical (If I remember what is in it right). and...
Forum: 125cc - 249cc 07-22-2015, 12:02 AM
Replies: 5
Views: 2,690
Posted By Dodgeme
pics of how you stretched it would be very...

pics of how you stretched it would be very helpful to determine if the stretch actually had any effect on it. I would look into getting the tire and wheel balanced as well especially when stretching,...
Forum: 125cc - 249cc 07-21-2015, 11:40 PM
Replies: 5
Views: 2,690
Posted By Dodgeme
You may have had a bad casting I've seen bad...

You may have had a bad casting I've seen bad castings do the same in cars, trucks (BIG TRUCKS gross weights around 80k) where all it takes is one flaw and some time and/or mileage and suddenly the...
Forum: Custom Builds 07-07-2015, 06:39 PM
Replies: 2
Views: 14,397
Posted By Dodgeme
Various parts have been purchased from companies...

Various parts have been purchased from companies to include scrappydogscooters.com, NYCscooterparts.com, partsforscooters.com, buggydepot.com, ecotrons.com, scoot-tuning.com and a few others
Forum: Custom Builds 07-07-2015, 06:36 PM
Replies: 2
Views: 14,397
Posted By Dodgeme
building a high performance 50cc engine

http://www.scootdawg.net/picture.php?albumid=110&pictureid=631http://www.scootdawg.net/picture.php?albumid=110&pictureid=635My current project is a qmb 139 engine that has over 5k miles on it. It...
Forum: 50cc - 124cc 07-07-2015, 06:16 PM
Replies: 1
Views: 3,792
Posted By Dodgeme
http://www.scootdawg.net/picture.php?albumid=110&p...

http://www.scootdawg.net/picture.php?albumid=110&pictureid=631http://www.scootdawg.net/picture.php?albumid=110&pictureid=638http://www.scootdawg.net/picture.php?albumid=110&pictureid=639I have a...
Forum: 50cc - 124cc 07-07-2015, 06:14 PM
Replies: 1
Views: 3,792
Posted By Dodgeme
Question exhaust crossovers

will a gy6 150cc exhaust fit on a qmb 139 engine also will a qmb 139 exhaust fit a gy6 150cc?
Showing results 1 to 23 of 23

 
Forum Jump

All times are GMT -4. The time now is 03:34 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.