Go Back   ScootDawg Forums > Search Forums
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Search: Posts Made By: spryDawg
Forum: 125cc - 249cc 10-10-2017, 12:06 PM
Replies: 4
Views: 1,225
Posted By spryDawg
I will try that. The scoot ran perfectly all...

I will try that. The scoot ran perfectly all summer. Sat for 10days and now it just won’t start. The intake manifold is also suspect, tho I’ve inspected it thoroughly for cracks. Something went wrong...
Forum: 125cc - 249cc 10-09-2017, 03:30 PM
Replies: 4
Views: 1,225
Posted By spryDawg
Troubleshooting Vac Leak

TaoTao 150cc not starting. Brand new carb. New batt. Manual petcock. Uni air filter. Valves set .004. Spark, compression, and fuel are all spot on. All carb hoses connected properly. I believe I’ve...
Forum: 125cc - 249cc 04-23-2017, 06:25 PM
Replies: 4
Views: 952
Posted By spryDawg
This was good advice. Thanks. The contacts were...

This was good advice. Thanks. The contacts were pretty clean but I sanded them down a little just be sure. Ran a second ground because the original is pretty thin. Unfortunately, I got the same...
Forum: 125cc - 249cc 04-23-2017, 11:06 AM
Replies: 4
Views: 952
Posted By spryDawg
Starts strong every time I let the engine cool...

Starts strong every time I let the engine cool down. I can replace the starter wire with an upgrade but I'm doubtful. Getting 13 volts from lithium battery after lots of use. Still can't figure why...
Forum: 125cc - 249cc 04-22-2017, 03:53 PM
Replies: 4
Views: 952
Posted By spryDawg
Start button short

Hello. I've got a problem with my starter button shorting the electrical system. It's starts up fine when cold but clicks once and then shuts everything off when warm. I know my scoot pretty well...
Forum: New Member Introductions 03-19-2017, 06:52 PM
Replies: 1
Views: 1,011
Posted By spryDawg
Hey all!

Ive been reading helpful posts here for over a year. After tweeeking and tuning all the easy stuff -I'm starting to get into the finer points of maintenance and customizing a 150 TaoTao. Glad to be...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -4. The time now is 01:58 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.