ScootDawg Forums - View Single Post

Madathlon · 05-24-2014, 05:46 PM

OKay, So I tore into the Scooter. Now here what I found. The Headlight, Dash and marker lights were all driven from the AC side of the Voltage Reg.

So here what I did.

After removing all the plastic I found the AC feed to the Hi/Low switch and cut it.

I then went to the main SW and found Consent 12vDC and switched 12vDC. Then I found an goos spot to mount an 12 VDC Automotive 5-Pin Relay SPDT.

I used 12g wiring and wired the relay into the main SW so that as I turned on the scooter the headlight with received power now from an independent 12vDC power source. and then from the relay I ran a wire up to the Hi/Low switch.

So there the easy fix to the flicker issue.

05-24-2014, 05:46 PM	#7
Madathlon Join Date: May 2014 Location: Redding, Ca Posts: 70	OKay, So I tore into the Scooter. Now here what I found. The Headlight, Dash and marker lights were all driven from the AC side of the Voltage Reg. So here what I did. After removing all the plastic I found the AC feed to the Hi/Low switch and cut it. I then went to the main SW and found Consent 12vDC and switched 12vDC. Then I found an goos spot to mount an 12 VDC Automotive 5-Pin Relay SPDT. I used 12g wiring and wired the relay into the main SW so that as I turned on the scooter the headlight with received power now from an independent 12vDC power source. and then from the relay I ran a wire up to the Hi/Low switch. So there the easy fix to the flicker issue.
	0