[DisillusionedPrepper]

Pretty busy with daily life so not much in progress.

I have several scooters, and loads of bodies (scooter bodies) laying about so I started trial fitting some of these bits.
This nose section is from something that I forget who made but it is a pretty close fit.
I also have the joining section that fits just below this. Soooo I'm kind of staring at it in the shop to decide which direction to pursue.

I'll re-post one of the earlier picts, and the new (orange body).
If anyone has an opinion on which one may lead to a cooler looking bike, than please chime in.
Keep in mind that all these bits will not be duct taped, and glued to the bike. I'm a fiberglass fabricator for a living. These parts are nothing more than a short cut to a desired outcome, and will be blended together (at some point in time).
Thanks!