|
Here is a lot simpler and cheaper solution:
1.. go to auto parts store and buy a vacuum 'T' or "Y' fitting with 3/16 inch nipples. a 12 inch piece of 3/16" fuel line and a can of starting fluid
2. remove your seat bucket
3. cut the vacuum line that runs to the auto fuel shutoff valve from the intake at about mid length at a good upward angle.
4. insert the vacuum T or Y fitting so that a more vertical nipple points upward and connect the new fuel line to that nipple
5. drill an inconspicuous hole into your seat bucket and route the new 3/16' fuel line through it
6. reinstall your seat with the hose through it.
7. insert a golf tee into the hose
When you need to start the scooter in extremely cold temps, simply raise the seat, remove the golf tee, spray some starting fluid (liquid) into the hose and wait for it to drain down. Start the scooter and then reinsert the golf tee, close the seat and wait for a couple minutes for the scooter temp to rise before riding
|