|
|
|
|
|
05-06-2015, 11:29 AM
|
#1 |
 Join Date: Dec 2014
Posts: 738
|
K & n
Just out of curiosity , I was wondering if anyone had luck with K & N Products? When I lived in NH , I used their air filters on a lot of Triumph engs that I built up (improved performance on ) I had very good luck with them! Everything is different here in Fla. Even different lubrications are used so I was wondering if anyone used these products.
 Irish
|
|
|
05-07-2015, 11:09 AM
|
#3 |
|
Join Date: Dec 2014
Posts: 738
|
K & n
Cheapto (sp?)---Did you notice any difference in performance? I put one in my 2006 Sportster 1200 w/ Trike Kit & I can't tell if there is any difference. It has so much power anyway that it's hard to tell without a run on the strip or a dyno test.
 Thanks! Irish
|
|
|
|
05-08-2015, 07:16 AM
|
#4 |
 
Join Date: Jul 2008
Location: York PA
Posts: 339
|
Oh yeah, I had to adjust the A/F setting. It was about that time I installed a TinyTach, to reset my idle setting properly.
There is a procedure to adjust my valves, when the engine is hot and running. But I found it damn near impossible to set it with out a tach. I could get it close, so I ran without the side covers on for a week or 2, making adjustments after the TT. I'm still not crazy happy with my settings yet, but the CON ride is coming up, so when I get down to North Carolina, I'll get one of the real mechanics to set it up for me proper like. Being a 250cc I try and squeek every bit of power from it that I can. Re-jetting/drilling out the port on the vacume slide, slider/roller combination, a blue Polini heavier contra spring in the variator. A Delta clutch is next years upgrade. Take care
__________________
Ride For Kids.org |
|
|
 |
|
|
Hybrid Mode
