|
|
03-21-2020, 05:33 PM | #1 |
Join Date: Mar 2020
Posts: 29
|
Honda Elite 80 speedometer visor plastic lock
Ok so for years I’ve been reading these forums and never joined. For what I’m about to ask, it would make any member doubt I’ve split the case on other scooters and done full engine rebuilds. That said, my elite 80 I’m stuck on attaching speedometer wind visor to the front handle cover. How do those black plastic locks work? Hammer or screw in, or another way?
Backstory, sourced a front handle cover (which go for a pretty penny) it was white, I color matched with America Red R191 paint. Somewhat happy with my paint job and clear on it. I do recall taking the screw lock off, some how the bottom part expands. |
04-12-2020, 02:07 PM | #2 | |
Join Date: Mar 2020
Posts: 29
|
Quote:
|
|
04-12-2020, 07:19 PM | #3 |
Join Date: May 2017
Location: Norfolk, VA
Posts: 597
|
Yamaha and Suzuki love push rivets! Here's a low down on how they work. To remove, you push the center in about half-way, and you can remove the push rivet from the outer flange. To install, the center pin needs to be in the upper position, about half(ish) way out of the push rivet. You install the rivet assembly with the center about half(ish) out, then press the center pin flush to "lock" it in position.
Sometimes, when removing the push rivet, the center pin will be tight and you'll accidentally push it all the way thru, loosing it in the abyss of the panels. And sometimes the center pin does not want to go into the "insert" position, and will pop out of the rivet assembly when forced in the up position. Center pin halfway depressed is un-lock. Center pin halfway out is insert position. Center pin flush is the locked position. Hope this makes sense. If you damage them, some better (Taylors Do-It Center, LOWES) hardware stores sell them either in the hardware section OR a hidden section in the automotive fastener section. Also some motorcycle shops will sell a pack of 10 in various sizes. I hated those when I first encountered them, now I actually like them. |
04-12-2020, 07:22 PM | #4 |
Join Date: May 2017
Location: Norfolk, VA
Posts: 597
|
Looking at those in the picture, they may be different? Try my method first and if it doesn't work, hit up a Honda Powersports dealership.
|
04-13-2020, 06:17 PM | #5 |
Join Date: Mar 2020
Posts: 29
|
1st of thank you so much for your response. Any input is appreciated. I find this challenge harder than clutch springs. When I removed these rivets they seemed obvious. I’m going to read your reply a few times and try playing around with them. Maybe I’ll make a video to show my confusion. That said really happy with the restoration project. Both rails are painted and installed. I ordered a new visor so I have some time to figure it out with these darn rivets.
|
04-13-2020, 06:49 PM | #6 |
Join Date: Mar 2020
Posts: 29
|
Video
|
|
|