|
03-11-2014, 04:43 PM | #16 |
Join Date: Jul 2008
Location: York PA
Posts: 339
|
When I was trying to figure put my lack of fuel issue, I found mine worked on TINY amounts of suction.
Mine is fit under the gas tank, with 2 nipples, gas out and (I think to a 3 way fitting one went to the carb) vacume line. So when it would not start, I'd remove the tubing from the Vac nipple, at the pump, attach a length of tubing that fits that nipple, then like priming a hose as you would to siphoning gas, except sipping in tiny amounts of pressure, the flow would start.....to much, or to hard, the flow would stop. So a 20" length of 1/4" tubing is in my tool kit under the seat. And, yes I did replace that pump, all hoses, and added tiny hose clamps to all hoses, completely removed the gas tank and cleaned it. It's still that way. Runs for while then I have to siphon it, it only takes me like 20 seconds now, but that sucks at a traffic light when it happens. |
03-12-2014, 09:48 AM | #17 |
Join Date: Mar 2013
Location: murphy n.c
Posts: 467
|
ok thanks.i'll try thaT
|
|
|