|
04-26-2015, 10:08 PM | #1 |
Join Date: Apr 2015
Posts: 2
|
Manual enriched was not connected. Now what?
Manual enricher was discovered to be not connected at the harness. The sellar can't be contacted to find out why.
I had ridden it for short 2 mile rides for a week and then it wouldn't start. I cleaned the spark plug and it started starting again. Plug was filthy black. Today I went to clean the carb and discovered that the Spark plug was filthy black after cleaning just a week ago. I also discovered that the enricher harness is not connected leading me to believe that the choke could have been on all the time. Am I correct? Oh yea, two things you should know: 1) adjusting the idle screw did nothing after getting to operating temp. 2) when riding it, after getting it to operating temp it would bog out like it was getting too much fuel. It also idled when riding better when I rolled off the throttle a bit. My question is, what should I do about the enricher being disconnected and it relating to the bogging? I live in Florida if that helps. Should I just block the area where the enricher goes with a plate? Would I need to jb weld the holes also? Last edited by Florida; 04-26-2015 at 10:54 PM. |
|
|