|
09-04-2016, 05:20 AM | #7 | |
Join Date: Jun 2016
Posts: 7
|
Quote:
The first thing I tried just now was connecting the BROWN/BLUE wire to the BLUE wire, turned on the ignition, and the high beam was working! I will correct myself from earlier, when I mentioned 'green' wire I meant to say 'dark green'. Is there a possibility that the dark green wire has a break somewhere? Because it doesn't seem to make any readings with negative or positive terminal of the battery. Perhaps when the switch connects the blue + dark green, it may not be completing the circuit. [edit] I just tested the switch again and I am most certain it is working as needed. To prove it, with the switch uninstalled, I put a jumper from the green wire to the blue wire and the high beams did not work. I can't quite figure out where the green wire leads to since it is wrapped up in a huge bundle that follows into a difficult part of the bike to get to. Last edited by blackout; 09-04-2016 at 06:50 PM. |
|
|
|