|
|
|
08-08-2013, 09:22 PM
|
#1 |
 Join Date: Mar 2013
Location: murphy n.c
Posts: 467
|
hard starting
I have a 2t jonway and its very hard to start.ive tried new plugs same thing.its a 50cc and runs great when warm.it has only a idle screw with a electic choke.talked to a scooter mech and he said check the reed valves.it only has a 100 miles on it and did put maybe half a gallon of regular and sta-bil in it.any ides?or should I just get a mikuni but don't no which one to get
|
|
|
08-09-2013, 09:13 AM
|
#2 |
Join Date: Jul 2011
Location: Connecticut
Posts: 493
|
Drain your fuel and replace with 91 or better octane. Your bike is not gonna run with regular.
__________________
2011 Roketa MC-23-150 4T 150cc 157 qmj 24mm carb w 115 main jet and paper cone air filter Manual petcock w Tygon fuel lines Scrappy Dog Scooters Retro-slash stainless straight-thru exhaust RED spring clutch Adjustable CDI (brand unknown, it's blue and red and works great!) KOSO high performance variator w 12g sliders Gates Powerlink 835-20-30 belt GPS verified 65mph on flats. |
|
|
|
08-09-2013, 11:45 AM
|
#3 |
Join Date: Sep 2011
Location: staunton va
Posts: 319
|
What is the plug gaped at. I doubt it has anything to do with your reeds since the scooter runs fine.What size jet do you have and what plug are you running
__________________
   2010 Cpi Oliver 70cc, naruku trans kit, downhill handle bars, tecnigas rsll pipe, s6 4g rollers, Vento R4 with 90cc 1e52qmf technigas next r 100cc pipe Naruku, 21mm race carb, s6 4.5 g rollers 
|
|
|
|
08-10-2013, 01:28 PM
|
#4 |
|
Join Date: Mar 2013
Location: murphy n.c
Posts: 467
|
I don't no about jets it just turned 110 miles.everything is stock.i did notice the tube coming from the tank(not to carb)I sucked on it and then blew in it and attatched it back it started.im wondering is that a vacuum deal.i don't no what plug but I remember its one that a lot of people use on this site ngkbr7?i gapped it at 32
|
|
|
|
08-11-2013, 01:49 AM
|
#5 |
|
Join Date: Sep 2011
Location: staunton va
Posts: 319
|
try gaping at .25 inch or .6 metric
__________________
2010 Cpi Oliver 70cc, naruku trans kit, downhill handle bars, tecnigas rsll pipe, s6 4g rollers, Vento R4 with 90cc 1e52qmf technigas next r 100cc pipe Naruku, 21mm race carb, s6 4.5 g rollers
|
|
|
 |
|
|
Linear Mode
