|
|
|
06-24-2014, 07:00 PM
|
#1 |
 Join Date: May 2014
Posts: 8
|
low beams tail light and auto choke don't work
i have a 2014 wolf rx 50. this morning i turned it on and 1 second after it started the low beams, side lights and tail lights went out. i also noticed the auto choke did not shut off after warming up. i flipped the switch for the high/low beams to turn on the high beams and when i did the high beams, side lights and tail light came on. also the auto choke shut off. so i had to ride to school at 530 this morning with the high beams on. when i got home i checked all voltages and they were good at all wires one connectors and they all have continuity. but still only the high beams work. i also noticed when i had the 9 pin plug unplugged by the buttons on the handle bar the side lights would come on but not the head lights. any ideas? i need to fix this asap as this is my only ride to school. thanks!
|
|
|
06-29-2014, 01:13 PM
|
#2 |
Join Date: May 2014
Posts: 13
|
Check the fuses and that connector to make sure there is no pins pushed out.
|
|
|
|
07-01-2014, 07:47 AM
|
#3 |
 
Join Date: Jul 2011
Location: Connecticut
Posts: 493
|
Check your main fuse wire (primary circuit).
Also check ALL frame grounds.
__________________
2011 Roketa MC-23-150 4T 150cc 157 qmj 24mm carb w 115 main jet and paper cone air filter Manual petcock w Tygon fuel lines Scrappy Dog Scooters Retro-slash stainless straight-thru exhaust RED spring clutch Adjustable CDI (brand unknown, it's blue and red and works great!) KOSO high performance variator w 12g sliders Gates Powerlink 835-20-30 belt GPS verified 65mph on flats. |
|
|
 |
|
|
Linear Mode
