Register FAQ Community Calendar Today's Posts Search
Go Back   ScootDawg Forums > Performance :: Maintenance :: Technical > 50cc - 124cc
Reply
 
Thread Tools Search this Thread Display Modes
Old 04-16-2016, 03:47 PM   #1
proudlefty   proudlefty is offline
 
Join Date: Apr 2016
Posts: 1
Pothole bump problem

Alright today was an eventful day as my scooter went from not working correctly to working correctly to my hopes being crushed as it didn't work correctly again. DISCLAIMER: I have little to no scooter maintenance experience, I bought a chinese 50cc scooter on craigslist because it was basically free and wanted to use it for little excursions. So my scooter has never been ready to roll immediately after starting. I normally kick start it, watch the back wheel begin to spin until it reaches peak RPM then slows down to an idle. Usually once it slows to a stop, I can pull the throttle and everything is ready to go. If I pull the throttle before it's "warmed up" then it usually responds a little and then just dies. So I let my scooter warm up but even after it settled to an idle after 5-10 mins I couldn't give it any throttle or it would die out. I tried adjusting the fuel mixture valve on the carb and also the idle speed to see if I could fix it. After turning the fuel mixture screw maybe 360 degrees all of the sudden I tried the throttle and I was able to get it revving up perfectly. I drove it for about a mile close to home thinking I had found the solution. Then I hit a pothole and the engine stopped responding to throttle again until it shut off. I pulled over and basically experienced the same problems as before. I tried putting the fuel mixture screw all the way in, all the way out, and everywhere inbetween with no luck. Could this be what originally fixed my problems or was it something else? How could hitting a pothole affect this? What do you think I should do? Once again, if you say "have you done _____" there's a 99% chance I haven't.



Login or Register to Remove Ads
  Reply With Quote
Old 04-17-2016, 05:56 AM   #2
bull   bull is offline
 
Join Date: Feb 2015
Posts: 257
sounds like the carb is stopped up

depending on whether you want to learn to repair your scooter or just get on it and go-- you could choose to either totally disassemble / rebuild your carb or simply replace it
  Reply With Quote
Old 06-08-2016, 10:36 PM   #3
scootercapecod   scootercapecod is offline
 
scootercapecod's Avatar
 
Join Date: Jun 2010
Location: Lower Cape Cod
Posts: 64
It sounds like your carb is a POS. I'd replace it for several reasons and amongst them are the float could be bad or stuck, something plugging up the jets like dirt, a bad drain valve screw seal a bad a/f screw seal or rubber seal leaking. Simply put you could be chasing down any or all of these issues so the better money spent would be on a new one.
__________________
Genuine Buddy 50CC 2T All stock. ASS, GAS OR GRASS...NOBODY RIDES FOR FREE!!!



Login or Register to Remove Ads
  Reply With Quote
Reply

Tags
engine, fuel, pothole, throttle, warm


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:48 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.