Go Back   ScootDawg Forums > Performance :: Maintenance :: Technical > Custom Builds
Reply
 
Thread Tools Search this Thread Display Modes
Old 01-26-2014, 11:23 AM   #1
makenzie71   makenzie71 is offline
 
Join Date: Jan 2014
Posts: 1
Need some shock suggestions for a 150cc custom setup, also intake manifold question

I'm running an open wheel setup with a single shock on the left side. Have any of you guys managed a linked shock setup working around a GY6? I have a very nice R6 shock I want to use if I can, but managing a link from the case's rear like it is from the factory is proving problematic. I'm just wondering if anyone here has manage to pull it off.

Secondly, this engine came with a rear facing intake manifold. I want it to point toward the front. I can make a new manifold but it would be nice if someone made one I could just buy. Anyone know of such a thing?

I'll put up a pic of my chassis here in a bit for a little more detail.



Login or Register to Remove Ads
  Reply With Quote
Old 12-28-2014, 07:57 PM   #2
mmsscooters   mmsscooters is offline
 
mmsscooters's Avatar
 
Join Date: Feb 2014
Location: las vegas
Posts: 100
Ive had to turn intake maifolds foreward for big carb builds, only issue i found was the plastics hitting the carb or air filter, dremel time
__________________
2012 Jonway X
44mm Hoca crank
52mm Hoca big bore
MMS big valve head raised ports, polished, milled .023
Hoca 26mm carb
NCY titanium valve springs
NOS wet nitrous system
Holley fuel pump
MMS variator
Naraku CDI
HT coil
4' Wheelie bar
MMG stainless slip-on exhaust
NGK "11" spark plug
UNI filter

2014 Icebear Maddog
too much to list
http://mmsscooters.com
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:33 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.