Go Back   ScootDawg Forums > Performance :: Maintenance :: Technical > 250cc +
Reply
 
Thread Tools Search this Thread Display Modes
Old 09-16-2017, 02:40 PM   #1
Jamesbb0   Jamesbb0 is offline
 
Join Date: Sep 2017
Location: Phoenix az
Posts: 6
Send a message via Skype™ to Jamesbb0
Binding issues

I have a Johnny yy250t I think with the vertical engine is that the cf moto one. Bought it thinking it was seized up wont crank over starters good. Pulled right case cover off and starter gear and starter spins freely put the gear back on without the cover and engine spins fine. When I put the cover on and tighten it down the engine goes back to not spinning but if I back the screws out a bit then it cranks fine. ???
Attached Images
File Type: jpg 0903171501.jpg (103.7 KB, 6 views)



Login or Register to Remove Ads
  Reply With Quote
Old 10-02-2017, 06:03 PM   #2
Shadowfire   Shadowfire is offline
 
Join Date: Feb 2015
Posts: 121
Well, to state the obvious, when you cranks down the cover, something is out of alignment.

The crank covers usually have two dowel pins which ensure that the cover and crank are aligned when you bolt the cover down. Were these still present? It sounds like they are missing and you are just using the bolts to align the cover.
  Reply With Quote
Old 10-03-2017, 01:25 PM   #3
Jamesbb0   Jamesbb0 is offline
 
Join Date: Sep 2017
Location: Phoenix az
Posts: 6
Send a message via Skype™ to Jamesbb0
No they are both in there still everything is straight no gaps it seems when could be pressing on the starter gear where that pulley shaft goes in the case side no washers just the gear.



Login or Register to Remove Ads
  Reply With Quote
Old 10-14-2017, 03:25 PM   #4
sc00ter   sc00ter is offline
 
Join Date: May 2017
Location: Norfolk, VA
Posts: 513
I was helping a friend fix a tired Honda Met (helping a cheapskate thread) and every time we put the reduction box cover back on a tightened it, it would bind. Loosen it up and it spun, just not correct. Ended up being a hairline crack in the cover. I NEVER would have found it, a tech at our local Honda dealership just happened to notice it. So, look for hairline cracks in the cover.
  Reply With Quote
Old 10-25-2017, 01:37 PM   #5
Jamesbb0   Jamesbb0 is offline
 
Join Date: Sep 2017
Location: Phoenix az
Posts: 6
Send a message via Skype™ to Jamesbb0
Hummmm have to look at that better not be only have that one cover lol and might not be common to find



Login or Register to Remove Ads
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:54 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.