Go Back   ScootDawg Forums > Media :: Reviews :: Classifieds :: General > General Scooter Discussion
Reply
 
Thread Tools Search this Thread Display Modes
Old 06-11-2014, 08:59 AM   #16
cheapeto   cheapeto is offline
 
cheapeto's Avatar
 
Join Date: Jul 2008
Location: York PA
Posts: 339
Adding Tyrebeads to my new CityGrips, as I had the shop to NOT balance them.
1 ounce to the front, two ounces to the rear.

It was so easy to add these to my tires. Put it on the center stand, remove the air and valve, then use either the tube (provided) over the valve stem, or the squeeze bottle, and squeeze the tyrebeads in to the tube/valve.

The rear tire was bit more tedious, as I have a 90 degree valve stem, I used a hose clamp around the tubing to help the beads fall into the valve a wee bit better.

Took about 20 minutes total. It was raining pretty hard when I got finished so no test until today.



Login or Register to Remove Ads

Last edited by cheapeto; 06-12-2014 at 07:51 AM. Reason: add to post.
  Reply With Quote
Old 06-18-2014, 11:10 AM   #17
blueboy5000   blueboy5000 is offline
 
blueboy5000's Avatar
 
Join Date: Jul 2011
Location: Connecticut
Posts: 493
Quote:
Originally Posted by Soulrider View Post
Took my cvt cover off but now I can't get it to go back on can some please tell me how to reinstall it . I own a 2014 Jonway yy150t-12 scoot.

I'm a tad confused, the cvt cover just slips onto the case, then you install the two LONG 8mm bolts in the rear, and then start all the other 8mm bolts, then tighten them, starting with the middle bolts in a spiral pattern, using a 1/4" drive ratchet and 8mm socket.
__________________
2011 Roketa MC-23-150

4T 150cc 157 qmj

24mm carb w 115 main jet and paper cone air filter

Manual petcock w Tygon fuel lines

Scrappy Dog Scooters Retro-slash stainless straight-thru exhaust

RED spring clutch

Adjustable CDI (brand unknown, it's blue and red and works great!)

KOSO high performance variator w 12g sliders

Gates Powerlink 835-20-30 belt

GPS verified 65mph on flats.
  Reply With Quote
Old 06-18-2014, 07:01 PM   #18
cheapeto   cheapeto is offline
 
cheapeto's Avatar
 
Join Date: Jul 2008
Location: York PA
Posts: 339
I did 345 miles from York PA to Roanoke VA, stand up at 8:00 am was lost in Roanoke by 3:00pm. My hotel is in Salem, and with construction and gazing about, caused me to put 45 miles EXTRA zeroing in on the Holiday Inn.
The BR was just flawless....so far!!



Login or Register to Remove Ads
  Reply With Quote
Old 06-19-2014, 10:18 AM   #19
kz1000st   kz1000st is offline
 
kz1000st's Avatar
 
Join Date: Oct 2008
Location: Hyde Park, NY
Posts: 1,054
I just did oil changes on the two scooters with no surprise debris present. Given that they both have over 8,000 miles I'm pleased. Other tasks yet to do that will be well worth the time.
__________________
2008 Eagle Milano 150- 9,679 miles
2009 Honda Rebel 250- 10,434 miles
2009 CF Moto Fashion- 16,023 miles
2009 MC-114 50cc Cub Clone- 4,317 miles
twowheeler.yolasite.com/

That's 30,049 China Scootin miles and Counting.
  Reply With Quote
Old 06-19-2014, 07:13 PM   #20
Firehawk989   Firehawk989 is offline
 
Join Date: Mar 2013
Location: Vancouver, BC
Posts: 198
Installed a new Malossi Yellow torque spring and torque controller to keep the engine in the powerband of the new pipe under acceleration. Works great, now I just need to figure out which clutch springs to use. (Have a set of 3 different ratings to try, plus my clutch has several adjustment options to fine-tune the launch RPMs.) This baby is very close to being dialed in the way I want!
__________________

2005 Yamaha BWS (Zuma) "Garfield"
TP Black Trophy 70cc, Giannelli Reverse Pipe, 5g Dr. Pulley Sliders, Delta Clutch with Yellow Springs and Yellow Contra, Malossi Torque Controller, Naraku R-Vent Bell, NCY Adjustable Secondary Sliding Sheave, CF Reeds, Kege Analog Tach, Dual Headlight Mod, N.A. Rear Fender Delete, OEM Short Windshield.



Login or Register to Remove Ads
  Reply With Quote
Old 06-20-2014, 05:59 PM   #21
rks   rks is offline
 
rks's Avatar
 
Join Date: Dec 2013
Location: Western New York
Posts: 454
Replaced the factory installed battery today. Not going to complain tho....did get two years, and 3 months out of it.
__________________
2011 Jonway 150cc..16,109 breakdown free miles, and counting

  Reply With Quote
Old 06-20-2014, 09:09 PM   #22
bandito2   bandito2 is offline
 
bandito2's Avatar
 
Join Date: Jan 2013
Location: Southeast Mchigan
Posts: 169
Yesterday I drilled and mounted the hitch connection for my single wheel trailer onto a rear spoiler/passenger hand grab that I got for dirt cheap off of ebay for the Silverwing scooter. (scratched up a bit, but I didn't care... I'm going for utility here) Besides, the rest of the bike has that patina and roughed up skin from actually being used as the workhorse it is. It has character. Not the prettiest little pony I've owned, but darn sure is the hardest worker.

And then today, no pics, but I changed a couple removable connections so that I can use my single wheel trailer with my Silverwing scooter. They were originally set up to work with My Reflex scooter, but the 2007 Reflex that used to pull the trailer is the subject of a streamlining project and so it is not being used to tow the trailer any more.

I never did much like doing electrical work on the bike because it is so tedious at times. All that unwrapping of sticky gummy tape to get at wires so that they can be reassigned to the proper connector pins. That and making darned sure wires are going to where they are supposed to. Check wire about 4X, cut, splice, check again, next wire, etc, etc, then check it all again. (don't want to burn anything) Test it, wrap it, try it again. OK. Put the tools away. Didn't have to do anything over, got it right the first time.

OK now the wiring is all good to go for the trailer lights plus the auxiliary lights that can be set atop stuff on the passenger seat. The tail lights on the bike are partially obscured by the trailer so the aux lights are needed. The tiny little lights down low on the trailer are pretty much cosmetic IMO. I really need to something with the tail lights that makes it safer... more visible.... A future project. (and I'll add pics of that project)

Actually, here is a pic with the extra set of lights on top of the stack O' stuff on the back seat of my 2007 Reflex. It got rearranged just a little bit so it could be seen better before I took off from here. Down on the ground behind the rear wheel is the shredded drive belt that got changed on the side of the road...... Yeah, lucky me....exit 13 LOL!! But it was more than luck.... that I was prepared with a spare drive belt and the tools to do the job some 700 miles from home.
__________________
Southeast Michigan Dark Side Rider
4 Honda Reflex scooters & a Big Ruckus
Originator of the
"Darkside" Honda Reflex.
"Yeah dude, that IS a car tire there on the back of my scooter."

Sometimes I'm so far outside of the box, the Hubble telescope can't find me
  Reply With Quote
Old 06-20-2014, 09:50 PM   #23
cheapeto   cheapeto is offline
 
cheapeto's Avatar
 
Join Date: Jul 2008
Location: York PA
Posts: 339
Damn nice work bandito!!
  Reply With Quote
Old 06-21-2014, 11:02 AM   #24
TheAmishSasquatch   TheAmishSasquatch is offline
 
TheAmishSasquatch's Avatar
 
Join Date: Jun 2014
Location: Philadelphia, PA
Posts: 8
Bought it last evening, rode and washed it this morning. Its an '07 Super 9 with only 1150 km and came with nice extras like a helmet, Tecnigas exhaust, and a Givi removable case. Its not the SR50 i wanted, but it'll do for now


  Reply With Quote
Old 06-21-2014, 03:48 PM   #25
wheelbender6   wheelbender6 is offline
 
wheelbender6's Avatar
 
Join Date: Mar 2010
Location: Houston area
Posts: 945
The wife and I scooted to a street fest in my town. I ate some awesome kimchi fries from a food truck. We shopped and tasted a few no-label brews (our local brewery). The sun was very strong and it was a hot scoot home.
__________________
"Beer never broke my heart" - Luke Combs
  Reply With Quote
Old 06-21-2014, 05:16 PM   #26
kz1000st   kz1000st is offline
 
kz1000st's Avatar
 
Join Date: Oct 2008
Location: Hyde Park, NY
Posts: 1,054
I've had to ride to Binghamton the last couple of days to visit. The Fashion is handling the 78 mile round trip well. I have to go a few more times and the scooter saves me a lot of gas over my cars. It's been surprisingly comfortable.
__________________
2008 Eagle Milano 150- 9,679 miles
2009 Honda Rebel 250- 10,434 miles
2009 CF Moto Fashion- 16,023 miles
2009 MC-114 50cc Cub Clone- 4,317 miles
twowheeler.yolasite.com/

That's 30,049 China Scootin miles and Counting.
  Reply With Quote
Old 06-23-2014, 01:35 PM   #27
cheapeto   cheapeto is offline
 
cheapeto's Avatar
 
Join Date: Jul 2008
Location: York PA
Posts: 339
Switched my honda oem air filter with a K&N. Adding some decals.
  Reply With Quote
Old 06-29-2014, 01:49 PM   #28
wheelbender6   wheelbender6 is offline
 
wheelbender6's Avatar
 
Join Date: Mar 2010
Location: Houston area
Posts: 945
The wife and I rode to a potential job site for a quick look over. It was difficult to find through through all the construction roads, but that added to the fun. After a week of commuting, its fun to take the scoots out for a little quest.
__________________
"Beer never broke my heart" - Luke Combs
  Reply With Quote
Old 06-30-2014, 12:43 PM   #29
kz1000st   kz1000st is offline
 
kz1000st's Avatar
 
Join Date: Oct 2008
Location: Hyde Park, NY
Posts: 1,054
Yesterday I got to enjoy a tripleheader. I took the Fashion to work and used the 50cc and 150cc bikes to fetch groceries in the morning and afternoon.
__________________
2008 Eagle Milano 150- 9,679 miles
2009 Honda Rebel 250- 10,434 miles
2009 CF Moto Fashion- 16,023 miles
2009 MC-114 50cc Cub Clone- 4,317 miles
twowheeler.yolasite.com/

That's 30,049 China Scootin miles and Counting.
  Reply With Quote
Old 10-05-2014, 08:33 PM   #30
rks   rks is offline
 
rks's Avatar
 
Join Date: Dec 2013
Location: Western New York
Posts: 454
Removed the rear wheel, got the tire irons out...removed the old tire (Kenda K413, 2300 miles), and installed the new one, (Michelin City Grip). Was 35 degrees this AM, so thought it would be good day to spend in the garage. Warmer tomorrow...will give it a road test then.
__________________
2011 Jonway 150cc..16,109 breakdown free miles, and counting

  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:42 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.