|
|
|
07-08-2014, 11:27 AM
|
#1 |
 Join Date: Mar 2013
Location: murphy n.c
Posts: 467
|
bbk
if I get a 70 or 80 cc bbk will I have to change rollers, clutch springs .I just want more take off power with out losing top end.i weigh 185 and I would like better take off and I think more ccs is what I need
|
|
|
07-16-2014, 02:08 AM
|
#2 |
|
Join Date: Mar 2013
Location: Vancouver, BC
Posts: 198
|
Yea if you keep the stock exhaust it should perform the same as stock but with more torque and faster up hills. Maybe slightly higher top speed.
You will have to upjet the carb and possibly adjust the needle position in the process.
__________________
 2005 Yamaha BWS (Zuma) "Garfield" TP Black Trophy 70cc, Giannelli Reverse Pipe, 5g Dr. Pulley Sliders, Delta Clutch with Yellow Springs and Yellow Contra, Malossi Torque Controller, Naraku R-Vent Bell, NCY Adjustable Secondary Sliding Sheave, CF Reeds, Kege Analog Tach, Dual Headlight Mod, N.A. Rear Fender Delete, OEM Short Windshield. |
|
|
|
08-01-2014, 06:17 PM
|
#3 |
Join Date: Feb 2014
Location: las vegas
Posts: 100
|
depends on 2 or 4 stroke, if its a 4 stroke dont touch a thing unless you are going to get high end parts like hoca, the chinese performance clutches are off balance. the springs and weights are referred to as "contra" meaning when you change one thing in the drive system it contradicts something else. clutch springs will launch at a higher rmp, BUT they will no grab hard, the torque spring will get you better takeoff but it will kill your top end
__________________
2012 Jonway X 44mm Hoca crank 52mm Hoca big bore MMS big valve head raised ports, polished, milled .023 Hoca 26mm carb NCY titanium valve springs NOS wet nitrous system Holley fuel pump MMS variator Naraku CDI HT coil 4' Wheelie bar MMG stainless slip-on exhaust NGK "11" spark plug UNI filter 2014 Icebear Maddog too much to list http://mmsscooters.com |
|
|
 |
|
|
Linear Mode
