|
|
|
08-26-2020, 09:23 PM
|
#1 |
 Join Date: Aug 2020
Posts: 2
|
Eton beamer matrix, minerelli clone?
Please excuse me for what might seem like a stupid question but I'm new to the scooter world. I purchased a 2005 eton beamer matrix 2t and I've been looking at performance parts. Finding parts by searching eton beamer matrix has been straight forward until I started looking for tuned pipes and can't find anything model specific. Best I can come up with is "for minerelli clone type" what I want to know is will this pipe fit my scoot?
|
|
|
08-28-2020, 08:31 PM
|
#2 |
|
Join Date: Aug 2020
Posts: 2
|
Anyone?
|
|
|
|
08-28-2020, 11:07 PM
|
#3 |
 Join Date: May 2017
Location: Norfolk, VA
Posts: 524
|
If I recall, and my memory is not that good, the exhaust port on the cylinder angled weird like a Genuine Rough House. Eton is a nice scooter but I have ever only seen one in person and it was bone stock. Guy had no urge to upgrade it. I remember reading somewhere in a tech section about Eton but I have no idea were I saw it. Moped Hospital in Florida maybe? But again, I think Eton has a weird angled exhaust out on the cylinder limiting your direct bolt on options. Check Racing Planet and Scooter Tuning.ca BUT be aware if you get a wrong fitting exhaust it will be a PITA to return. If possible try a Tecnigas R or RS (depending what your goals are) for a affordable "test fit" if they have one listed for a Eton.
|
|
|
 |
|
|
Linear Mode
