Register FAQ Community Calendar Today's Posts Search
Go Back   ScootDawg Forums > Search Forums
Reload this Page Search Results
Page 1 of 2 1 2
Showing results 1 to 25 of 30
Search took 0.00 seconds. Search: Posts Made By: Castle_Rock
Forum: 125cc - 249cc 12-17-2013, 04:58 PM
Replies: 8
Views: 6,766
Posted By Castle_Rock
I replaced the cdi wiring, it now fires properly....

I replaced the cdi wiring, it now fires properly.

Also if I replace the standard vacuum-based petcock, will this type...
Forum: 125cc - 249cc 12-07-2013, 11:03 AM
Replies: 27
Views: 16,891
Posted By Castle_Rock
Just last month I ran over 230 miles from...

Just last month I ran over 230 miles from Indianapolis, IN to Gary, IN with no issues on my stock GY6 Roketa 150 bike, not saying I could do it again and have no issues, but just sayin, their just as...
Forum: 125cc - 249cc 12-05-2013, 10:58 AM
Replies: 8
Views: 6,766
Posted By Castle_Rock
When I put the coil with spark plug next to the...

When I put the coil with spark plug next to the cylinder head, I see spark, so I now have spark, compression has always been there and assume I am still getting fuel - it still won't start.

Am I...
Forum: 125cc - 249cc 12-04-2013, 09:25 PM
Replies: 8
Views: 6,766
Posted By Castle_Rock
I performed a Ohm reading on the magneto and got...

I performed a Ohm reading on the magneto and got .488.

I swapped my standard cdi to the racing and receive a blinking green light which acts as its getting power, not sure why i am not getting...
Forum: 125cc - 249cc 12-04-2013, 06:51 PM
Replies: 8
Views: 6,766
Posted By Castle_Rock
Installed the new motor, nothing - it acts the...

Installed the new motor, nothing - it acts the same.
Forum: 125cc - 249cc 12-01-2013, 01:46 PM
Replies: 8
Views: 6,766
Posted By Castle_Rock
the thing about fuses is I have only found one by...

the thing about fuses is I have only found one by the battery, where I also installed a inline for the 12V outlet.
I have not found any other fuses if there were supposed to be.

Like I said, it...
Forum: 125cc - 249cc 11-30-2013, 11:10 AM
Replies: 8
Views: 6,766
Posted By Castle_Rock
Also, would a bad starter motor cause low top end...

Also, would a bad starter motor cause low top end speed? I don't think so but am just checking.
Forum: 125cc - 249cc 11-29-2013, 10:02 AM
Replies: 8
Views: 6,766
Posted By Castle_Rock
I bridged the solenoid and do not hear any...

I bridged the solenoid and do not hear any clicking - maybe that it part of my issue.

Also I tested the starter motor and it is registering less than 1V, I think that may have been the issue, so I...
Forum: 125cc - 249cc 11-28-2013, 07:41 PM
Replies: 8
Views: 6,766
Posted By Castle_Rock
Bike won't start

My roketa won't start as of today.

I took the cvt cover off and while turning the variator fan, noticed I wasn't hearing that "whoosh" sound it normally makes.

Also when ignition is on, I...
Forum: 125cc - 249cc 11-25-2013, 09:13 AM
Replies: 10
Views: 7,728
Posted By Castle_Rock
I still have the kick start issue, i followed the...

I still have the kick start issue, i followed the posting HERE (http://scootdawg.proboards.com/thread/21772) - however it still feels like it does not sit properly - I don't believe I am missing any...
Forum: 125cc - 249cc 11-23-2013, 11:09 AM
Replies: 10
Views: 7,728
Posted By Castle_Rock
I am pleased to announce the bike has been fixed...

I am pleased to announce the bike has been fixed - with a help of a good friend, we found the fuel filter was the culprit - it had quite a bit of sediment in there - once replaced, the bike runs up...
Forum: 125cc - 249cc 11-19-2013, 07:25 PM
Replies: 10
Views: 7,728
Posted By Castle_Rock
Mine has a cable slide. There is no grass in...

Mine has a cable slide.

There is no grass in the muffler, and i can feel air coming out the end.

When i am WOT, i hear nothing. Sounds the same as before.

One thing i forgot to mention...
Forum: 125cc - 249cc 11-19-2013, 04:25 PM
Replies: 10
Views: 7,728
Posted By Castle_Rock
I checked the cable this morning and it opens...

I checked the cable this morning and it opens like it should, I'm starting to think its something internal. Any idea what specific part of the engine i should check?
Forum: 125cc - 249cc 11-19-2013, 02:51 PM
Replies: 10
Views: 7,728
Posted By Castle_Rock
I checked the roller weights, no dice - their all...

I checked the roller weights, no dice - their all there. I don't know what weights they are, but may change them out.

I notice that my throttle is still very responsive - however i still only go...
Forum: 125cc - 249cc 11-18-2013, 02:14 PM
Replies: 10
Views: 7,728
Posted By Castle_Rock
Also when i took the cvt cover off, the manual...

Also when i took the cvt cover off, the manual kick start seems to be broken, as it comes right off and when i do kick it, it does not return to start position.
Forum: 125cc - 249cc 11-18-2013, 01:09 PM
Replies: 10
Views: 7,728
Posted By Castle_Rock
wrecked bike issues

My speed has been reduced to 15mph - and it still runs - but i am trying to figure out why i have lost throttle.
We experienced high tornado wind yesterday and i was going about 40mph when the wind...
Forum: 125cc - 249cc 11-10-2013, 03:54 PM
Replies: 9
Views: 9,116
Posted By Castle_Rock
Yup, it must've been a bad ground - but I got an...

Yup, it must've been a bad ground - but I got an extended gauge wire to expand the positive and added a switch so it don't need to be on or initiated at every ride....
Forum: 125cc - 249cc 11-09-2013, 06:18 PM
Replies: 9
Views: 9,116
Posted By Castle_Rock
I got the outlet installed in the glovebox and it...

I got the outlet installed in the glovebox and it does work (I tapped into the black wire for the horn) and it turns on when the key is on - however I think it may be overloading the circuit as it...
Forum: 125cc - 249cc 11-06-2013, 12:00 PM
Replies: 9
Views: 9,116
Posted By Castle_Rock
Ok, I will see about doing that - running it to...

Ok, I will see about doing that - running it to the horn is a good idea
Thanks
Forum: Scooter Safety Forum 11-06-2013, 10:51 AM
Replies: 22
Views: 50,577
Posted By Castle_Rock
I just bought a "eyecord" brand sunglasses with...

I just bought a "eyecord" brand sunglasses with camera that records in 720P - have yet to try it but it runs for hour and a half which is more than what I drive on a daily basis. Might be good...
Forum: 125cc - 249cc 11-06-2013, 09:47 AM
Replies: 5
Views: 6,664
Posted By Castle_Rock
Thanks, I finally found the port and reconnected.

Thanks, I finally found the port and reconnected.
Forum: 125cc - 249cc 11-02-2013, 03:19 PM
Replies: 5
Views: 6,664
Posted By Castle_Rock
unfortunately I pulled too much to see, it may...

unfortunately I pulled too much to see, it may not go to anything, it might be a drain hose or air - I may need to pull that CVT cover off again and see what's there.
Forum: 125cc - 249cc 11-02-2013, 10:13 AM
Replies: 5
Views: 6,664
Posted By Castle_Rock
Anybody there?

Anybody there?
Forum: 125cc - 249cc 10-31-2013, 11:06 AM
Replies: 5
Views: 6,664
Posted By Castle_Rock
Hose came unplugged

After I got home 2 days ago, I noticed this grey hose(attached) was loose, and I pulled it to make sure if it was connected, couldn't see where it went to - but everything seems to still work...
Forum: 125cc - 249cc 10-23-2013, 05:45 AM
Replies: 9
Views: 9,116
Posted By Castle_Rock
I browsed harbor freight freight's site but only...

I browsed harbor freight freight's site but only see the alligator clip type which would be fine - though it is not waterproof. The nearest store is Half an hour away either direction. Maybe they...
Showing results 1 to 25 of 30
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 06:32 AM.

Contact Us - ScootDawg.net - Archive - Top
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.