Help! Check out my cylinder head... wont start

[ldizzle]

Hey guys,

It's been awhile since I've posted...so far back, that it was the other forum.
I have two scoots and a couple of big bikes - one of my scoots, however, is just giving me the worst.

2007? baja sc150- generic chinese gy6 -1700miles

I began to have major issues with the valves, and a warning sign was raised when i had to adjust them every couple hundred miles. Well, every couple of hundred went to every single ride. I've heard the metal on these guys is sometimes poor...

Then, after paining this for awhile, the valve adjustment had 0 give on the intake side and will not start.

The thread i posted about this years ago, everyone told me to just replace the head- I want to make sure this is my issue - here's a picture of the inside of the current head I just took off this morning.

The fuzz on the r valve is paper towel from trying to scrub it.

Take a look- any advice is welcome.